Copyright & ©2019  Pearl Communication Technology ( Shenzhen ) Co., Ltd.  粤ICP备19040850号 Powered by 300.cn

Message

CONTACT

Add: No. A I Bldg., Fuchengao; Ind. Dist., Pinghu, 
Longgang Dist.,Shenzhen 518111 ,P.R. China

Tel:  +86-755-84671906, +86-755-84671101

Fax: +86-755-84671103

E-mail: szpct@vip.163.com, salesoffice@pct.net.cn

Website: http://www.pct.net.cn

PRODUCTS

PRODUCTS

>
Products_Details

PRODUCTS

Heat shrinkable welded casing

Page view:

Heat shrinkable welded casing

没有此类产品
Product description
1. Exterior
 
1.1 The thickness of the fiber-filled tube is uniform and the end surface is flat;
 
1.2 The inner and outer surfaces are clean and free from defects such as impurities and dust;
 
1.3 The appearance is smooth and smooth, without defects such as bending, lifting, scratching.
 
 
 
2. Reinforcement
 
2.1 The single-core welded sleeve reinforcement material is stainless steel; the ribbon welded sleeve reinforcement material is ceramic
 
2.2 The reinforcement is not easy to bend, deform, and has sufficient strength;
 
2.3 The appearance is smooth and flat, and there are no defects such as rust, impurities and dust.
 
 
 
3. length
 
3.1 strip shape: 40mm ± 1mm
 
3.2 Single core: 60mm ± 1mm
 
 
 
4. specification
 
Single core: outer diameter φ3.
 
Ribbon: 4 cores to 8 cores, 12 cores;
 
 
 
5. Fusion performance
 
5.1 Welding temperature: 180 °C ± 10 °C
 
5.2 Welding time: 2 to 3 minutes
 
5.3 Axial shrinkage: <2%
 
5.4 After heat shrinkage welding, the performance of heat shrinkage welding is sufficient and uniform, no defects such as bubbles, deformation and lifting are visible, heat shrinkage is firm, and no additional loss is caused to the optical properties of the fiber joint.
 
6. The product picture is as follows:
 
XX
Φ3 single core heat shrinkable welded sleeve diagram
 
XX
12-core ribbon double-sided ceramic heat shrinkable protective sleeve
 
7. Product instructions
 
7.1 After the fiber is butt-joined according to the specified requirements and order, move the 2007-06-13 heat-shrinkable casing to the center of the fiber fusion point.
 
7.2 Welding according to the following welding conditions: welding temperature: 180 °C ± 10 °C; welding time: 2 to 3 minutes.
 
7.3 Performance requirements after heat shrinkage: heat shrinkage is sufficient and uniform, no defects such as bubbles, deformation, lifting, etc. are visible, heat shrinkage is strong, and no additional loss should be caused to the optical properties of the fiber optic connector.
Corresponding parameter set not found, please add it in property template of background
暂未实现,敬请期待
暂未实现,敬请期待
Previous article
Next article